Mixing cerium oxide in baby oil, I used it to micro-polish lathe friction-bearing surfaces (ways, cross-slide, compound tool rest etc.). This followed doing the same thing with silicon-carbide grit in baby oil. One can feel the surface machined roughness disappearing by the stroke. It only takes a few minutes of rubbing the parts back & forth. `works fantastically. The saddle/carriage slid so smoothly, I could push it with the palm of my hand and just watch the carriage wheel spin. REALLY nice ... Afterwards, adjusting the gibs is easier i.e. more consistent friction, too. Especially until mixed with baby oil, be careful to wear a face mask because, if either silicon-carbide or cerium oxide dust gets airborne and into your lungs, it will NEVER degrade or leave ... and would provide the agitation for accelerated cell growth i.e. cancer. Please take this SERIOUSLY and be careful using these wonderful, but powerful compounds.Read full review
Verified purchase: Yes | Condition: New
This stuff id great. I used a terry cloth on my Orbital Buffer put some water on it, then sprinkled on the Powder. I took my time going up and down and the back and forth. I would stop for a few min. let it dry and then go over it again with out adding any powder. Spent 30 min on each side and got most of the little pits that show up when a Car is coming at you at night that causes glare. The Car has 170,000 miles on it and the Windshield looks great! It is great stuff and I also used it to get scratches off of my GPS screen.
Verified purchase: Yes | Condition: New
I bought that for stone cutting. it ain't exactly my trade, more like a hobby but my research led me to this stuff for the final stages. after cutting to the desired shape I used this product to obtain a shiny polish. It works like a charm. if you too are cutting stones, this will prove useful to you, it's inexpensive and it lasts long if you use it correctly. would recommend it to anyone planning to use it for the purpose of stone cutting
Verified purchase: Yes | Condition: New
This Cerium Oxide is top quality. I polished the windshield on my 2009 Cadillac CTS with amazing results. Bye bye wiper scratches. I highly recommend this product!
Verified purchase: Yes | Condition: New
Good quality cerium oxide is getting harder to get at a competitive price, I cut cabs and tumble lots of agates and jaspers. The end result was a mirror glass polish. The color of this cerium is a darker orange than I am used to and was skeptical of its grade quality. Finishing a tumble gave me great results and I have a new reasonable price source of cerium. Go for it!
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Tools & Supplies
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Tools & Supplies