DS350GW DISPLAY AND A2B switch 31-002-06-0011

When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.

DS350GW DISPLAY AND A2B switch 31-002-06-0011 :
$6000.00

THE HIRSCHMANN PAT DS350GWLOAD MOMENT INDICATOR SYSTEM CONSISTS OF A CENTRAL MICROPROCESSOR UNIT, OPERATOR’S CONSOLE, AND COMPONENT SENSORS FOR ANGLE, LOAD, AND ANTI-TWO BLOCK (A2B) CONDITION.

The Hirschmann PAT DS350GWsystem uses angle sensors to measure boom and jib angle, if applicable. The hoist line force transducer measures the load. And the A2B switch senses an approaching a two block condition.

The DS350GWoperates on the principle of comparing real to reference data. The real data is supplied to the central unit by sensors and the operator’s input settings, such as: operating code, hoist selection switch, and reeving switch. The reference data (i.e. crane capacity charts, geometry) is supplied by the crane manufacture and stored in memory chips in the central processor unit. The microprocessor evaluates the real data (sensors and operator input) to determine an operating mode. The operating mode determines the reference data required to calculate permitted operating limits. When limits are exceeded, warning signals are generated and viewed at the operator’s console. Note the difference between operator’s code and mode; the code is entered by the operator from Appendix, and the system defines the mode