WW2 FIRESTONE Mfgr US M-1 HELMET LINER Type-8 nr. w/ 2-Washer Repairs


WW2 FIRESTONE Mfgr US M-1 HELMET LINER Type-8 nr. w/ 2-Washer Repairs

When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.


Buy Now

WW2 FIRESTONE Mfgr US M-1 HELMET LINER Type-8 nr. w/ 2-Washer Repairs:
$101.00


WW2 Vintage US M-1 HELMET LINER Type-8 High Pressure Plastic FIRESTONE mfgr marked
FIRESTONE mfgr TYPE-8 WW2 US M1 HELMET from my helmet collection.
came from the same batch of surplus disposal warehouse dead stock obtained REPAIRS:-two inverted A-washers have been replacement repaired with a \'hollow\' holding rivet.probably done postwar by?SPECS:
-type 8 high pressure plastic liner (Oosterman classification)
-FIRESTONE mfgr logo mold marked with \'A 12\' below the F-shield logo
- khaki tan HBT multiple-Vee web suspension with leather sweatband dye discoloration.
has mfgr VOGT \'V\' ink stamped in (2) places
-the webbing appears to have been little used.
-corrosion inhibitor coated finish on the inverted A washers..(2) are replaced by hollow rivet
-female neckband snap buttons are \'U.C.F.C.\' (UNITED CARR FASTENER CO.) markedand rivet snaps & are mildew inhibitor coated.
-undimpled brass metal garter studs w/ corrosion inhibitor coating
-has the triple HBT ROUOND center lace tie cord w/ NO fraying off the end tipsEXTERIOR:
-GOOD! textured phenolic resin OD exterior factory finish which is 98% present AND ORIGINAL!
with some very minimal scratches/abrasion scrapes, scuffs.
-feels like fine grit sandpaper. surface is NOT WORN SMOOTH!
-good amount of factory OD paint still covering the front brass eyelet grommet and all outer rivet heads...
-center brass eyelet grommet has its OD paint finish intact
COND:
-there is \'V\' shaped upper dome crack....goes thru the fiberglass-there is 1/4\" edge tear on the left side edge-there are two tiny tiny edge nicks on the right side edge-CONDITION - as described
basically a 100% honest late war liner.ONCE inside a STEEL POT....you can\'t really tell the difference
-if you purchased from me before....you know where i\'m coming from.
THERE is a ton of images provided below.....ref images: reynosa, oosterman
guaranteed 100% WW2 vintage....NOT A MOVIE PROP, NOT A REBUILT HELMET, NOT A REPRO

Eastern and orcommunist countries.

there is .postage is $15.95 PRIORITY MAIL with tracking number (within the US).

high buyer must make contact within 3 days AND payment must be rec\'d

within THREE!!!days of closing otherwise item to be forfeited and NO-PAYING buyer STRIKE-issued.

All alternate payment methods accepted.

NOhidden Reserve! All SOLD as IS! NORETURNS!

US POST OFFICE raised 1st class & Priority rates again!


On Aug-14-18 at 11:22:51 PDT, seller added the following information:


WW2 FIRESTONE Mfgr US M-1 HELMET LINER Type-8 nr. w/ 2-Washer Repairs:
$101.00

Buy Now